Gill windsonic manual

Screw the back shell onto the connector until it is fully in place. Please note that the final Page 16 Now screw the cable-clamping nut into place. The connector can now be removed from the WindSonic. NOTE: To disassemble the connector, reverse this procedure.

Page Installation 7. Operating in diverse environments all over the world, WindSonic requires no calibration and adjustment whatsoever. Page Bench System Test November 7. Page 20 See Section 7. Page 21 Baud rate set to this can be at variance with the original WindSonic Baud rate setting. After approximately 3 seconds the unit will respond with Safe Mode.

Page Connecting Analogue Outputs are also simultaneously available from the Option 3 unit. Page Using Rs WindSonics must be set in Polled mode, a node address letter may be given if required. See Section 9. Customers may poll using terminal software NOT supplied. As unit is point to point only it cannot be networked with other RS 2 wire devices. The current output loads must be returned to Signal Ground. Page Mechanical 1. It is the responsibility of the customer to ensure that the WindSonic is mounted in a position clear of any structure, which may obstruct the airflow or induce turbulence.

Page 30 This enables the host system to check that the data has been correctly received. Figure 5 shows the polarity of U and V if the wind components along the U and V axis are blowing in the direction of the respective arrows.

Page 32 9. The Gill Status codes are as described in Para Analogue signals are output continuously when in Digital Polled Mode. Note: - The WindSonic provides the power for current output loads. Do not connect the WindSonic output to instruments where power for the current loop is provided by the Page Low Wind Speeds Below 0.

WindSonic 75 units will report Error conditions as though set for Y1 below. Page 39 For instance if the unit is set for v analogue outputs and it is required to report a fixed voltage level of 3. Page 40 Windows HyperTerminal. This section describes the commands used to change User and Communications settings. When selected a similar message to that below will be seen. The following screen will show settings that will be changed.

Select the required Baud rate from the drop down list. Parity should be set to None. If the Baud rate setting of the Anemometer is unknown then the Auto Find button can be used to interrogate the Anemometer and detect the required setting.

To change displayed units select and click on required measurement units. If segmented logging is required this will create and save individual files of length set by the figure in the mins box. Otherwise a continuous log file will be recorded.

Example saved data opened in Notepad. Page 49 Enter a Name eg WindSonic 1. WindSonic default settings are : Bits per second Data bits Page Hecking The Configuration The new setting will be sent as a message by the WindSonic.

Page Fx - Data And Parity Options If the power up message is On, then a message similar to that below is output, whenever the unit goes into Measurement mode i. Item Command Response Type and serial No. Opening the unit or breaking the security seal will void the warranty and the calibration. In the event of failure, prior to returning the unit to your authorised Gill distributor, it is recommended that: All cables and connectors are checked for continuity, bad contacts, corrosion etc.

Check that the unit is correctly configured by going into Configuration mode and using D3 See Section Compatible Products MetSet is compatible with the following products:. Download MetSet v2. Compatible Products MetView is compatible with the following products:.

For MetPak models with serial numbers lower than please contact anemsupport gillinstruments. Download MetView v2. Overview Wind is a PC application which can be used to configure Gill wind sensors. Compatible Products The Wind application is compatible with the following products:.

Download Wind v Kb. Compatible Products The WindView application is compatible with the following products:. Download WindView v 4. Mscan will list the IP addresses of any connected MetStream units to enable the user to connect to the MetStream using a browser. By connecting to the MetStream the user can display the data collected by the MetStream using the display application included in the MetStream.